Ford Ecosport Owners and Service Manuals

Ford Ecosport: Exterior Lighting / General Procedures - Front Fog Lamp Adjustment

Ford Ecosport 2014-2026 Service and Repair Manual / Lighting / Exterior Lighting / General Procedures - Front Fog Lamp Adjustment

Adjustment

  1. NOTE: Horizontal aim is not adjustable. Consult your state vehicle inspection center for recommended tolerance ranges for visual aiming.

    NOTE: Before starting fog lamp adjustment, entry conditions must be met.

    • Vehicle must be on level ground.
    • Tires must be correctly inflated.
    • Vehicle must be normally loaded.
    • Fog lamps and headlamps must be clean.
    • Air suspension switch must be on (if equipped).
    • Headlamps must be operating and correctly aimed.
  1. NOTE: The vertical wall screen must be a minimum of 3m (10 ft) wide.

    Park the vehicle on a level surface approximately 7.6 m (25 ft) from the vertical wall or screen directly in front of it.
  1. The correct visual aim for the fog lamps is with the top edge of the high-intensity zone 101.6 mm (4 in) below the horizontal center of the fog lamps.

    Diagnosis and Testing - Turn Signal and Hazard Lamps

    DTC Chart: BCM Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation)...

    General Procedures - Headlamp Adjustment

    Adjustment NOTE: If the flash video link does not load or is incompatible with your browser, a .wmv version of the video can be accessed at: http://www...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Diagnosis and Testing - Charging System


    Inspection and Verification Verify the customer concern by operating the charging system. Before diagnosing or repairing the charging system inspect the following items: Check the battery for loose, damaged or corroded connections...

    Ford Ecosport 2014-2026 Service and Repair Manual: General Procedures - Seatbelt Tongue Rotated On Belt


    Adjustment NOTE: Typical seatbelt tongue shown, others similar. Fold the seatbelt as indicated. Feed the folded portion of the seatbelt into the seatbelt tongue. Pull the seatbelt through the seatbelt tongue to remove the twist in the seatbelt...

    Categories

    Removal and Installation - Oil Pressure Switch

    Materials

    Name Specification Motorcraft® Thread Sealant with PTFE
    TA-24-B WSK-M2G350-A2
     

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    With the vehicle in NEUTRAL, position it on a hoist.
    Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
    If equipped, remove the bolts and the underbody shield.

    read more

    Copyright © 2026 www.foecosport2.com