Ford Ecosport: Front Seats / Removal and Installation - Front Seat Control Switch
Removal
NOTE:
LHD driver seat shown, RHD driver seat similar.
-
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
-
Release the retainer and remove the manual lumbar handle.
-
-
Remove the side shield screw.
-
Lift the rear of the side shield up and out.
-
Slide forward and position the side shield aside.
-
Position the front seat control switch support bracket aside.
-
Detach the front seat control switch wiring harness.
-
Remove the screws.
-
Disconnect the electrical connectors and remove the side shield.
-
Release the tabs and remove the front seat control switch.
Installation
-
To install, reverse the removal procedure.
Special Tool(s) /
General Equipment
Hog Ring Plier
Removal
WARNING:
Front seat backrest trim covers installed on seats equipped
with seat side airbags cannot be repaired...
Special Tool(s) /
General Equipment
Hog Ring Plier
Removal
NOTE:
Driver seat shown, except where called out.
NOTE:
Follow the unique instructions or graphics for this step when installing a front passenger seat equipped with OCS...
Other information:
Special Tool(s) /
General Equipment
Resistance Spotwelding Equipment
8 mm Drill Bit
MIG/MAG Welding Equipment
Spot Weld Drill Bit
Locking Pliers
Materials
Name
Specification
Seam SealerTA-2-B, 3M™ 08308, LORD Fusor® 803DTM
-
Removal
NOTE:
The inner quarter panel is constructed of mild steel and
High-Stre..
Refer to Wiring Diagrams Section 310-03 for schematic and connector information.
General Equipment
Ford diagnostic equipment
Inspection and Verification
Verify the customer concern by operating the system.
Visually inspect for obvious signs of mechanical or electrical damage.
Visual Inspection Chart
Mecha..