Ford Ecosport Owners and Service Manuals

Ford Ecosport: Handles, Locks, Latches and Entry Systems / Removal and Installation - Exterior Front Door Handle

Removal

NOTE: LH side shown, RH side similar.

Vehicles with push button start

  1. Remove the front door trim panel
    Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
  1. Remove the front door watershield.
  1. Disconnect the exterior front door handle electrical connector.

All vehicles


  1. Remove the access plug and the exterior front door handle retaining screw.
    1. Remove the access plug from the front door.
    1. Remove the exterior front door handle retaining screw.
  1. Remove the exterior front door handle trim cover and if equipped, remove the front door lock cylinder.
  1. NOTE: Vehicles with push button start shown, others similar.


    Remove the front exterior door handle.
    1. Pull the exterior front door handle rearward.
    1. Remove the front exterior door handle.

Installation

  1. To install, reverse the removal procedure.
  1. Rotate the key to check for correct operation.

    General Procedures - Staged Unlock Programming

    Programming   WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information...

    Removal and Installation - Exterior Rear Door Handle

    Removal NOTE: LH side shown, RH side similar. Remove the access plug and the exterior rear door handle retaining screw. Remove the access plug from the rear door...

    Other information:

    Ford Ecosport 2014-2026 Service and Repair Manual: Description and Operation - Pyrotechnic Device Health and Safety Precautions


      WARNING: Service and handling of Pyrotechnic Components is restricted to qualified personnel. The required qualifications vary by region. Always observe local laws and legislative directives regarding Pyrotechnic Components service and handling...

    Ford Ecosport 2014-2026 Service and Repair Manual: Removal and Installation - B-Pillar Side Impact Sensor


    Removal   WARNING: The following procedure prescribes critical repair steps required for correct restraint system operation during a crash. Follow all notes and steps carefully. Failure to follow step instructions may result in incorrect operation of the restraint system and increases the risk of serious personal injury or death in a crash...

    Categories

    Removal and Installation - Variable Camshaft Timing (VCT) Unit

    Removal

    NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan can cause engine failure.

    Remove the timing chain.
    Refer to: Timing Chain (303-01C Engine - 2.0L Duratec-HE (129kW/175PS), Removal and Installation).
    Remove the bolts and VCT units.
    Discard the bolts.

    read more

    Copyright © 2026 www.foecosport2.com