Ford Ecosport Owners and Service Manuals

Ford Ecosport: Handles, Locks, Latches and Entry Systems / General Procedures - Staged Unlock Programming

Programming

  1.   WARNING: Before beginning any service procedure in this manual, refer to health and safety warnings in section 100-00 General Information. Failure to follow this instruction may result in serious personal injury.

    Refer to: Health and Safety Precautions (100-00 General Information, Description and Operation).
  1. With the ignition in OFF, press the lock and unlock buttons on the RKE transmitter simultaneously for 4 seconds.
  1. The turn signals flash twice to indicate the mode change.
  1. Repeat Step 2 to enable/disable the staged unlocking feature.

    General Procedures - Door Latch Lubrication

    Special Tool(s) / General Equipment Flat-Bladed Screwdriver Materials Name Specification Motorcraft® Multi-Purpose Grease SprayXL-5-A ESB-M1C93-B  Activation NOTE: Typical left front door shown, others similar...

    Removal and Installation - Exterior Front Door Handle

    Removal NOTE: LH side shown, RH side similar. Vehicles with push button start Remove the front door trim panel Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation)...

    Other information:

    Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Transfer Case


    Principles of Operation The AWD system may be referred to as a 4WD system in other service information and owner literature or messages located on the message center. The transfer case or power transfer unit is a gearbox that is attached to the transmission...

    Ford Ecosport 2014-2025 Service and Repair Manual: Diagnosis and Testing - Air/Fuel Ratio


    Diagnostic Trouble Code (DTC) Chart Diagnostics in this manual assume a certain skill level and knowledge of Ford-specific diagnostic practices. REFER to: Diagnostic Methods (100-00 General Information, Description and Operation). Module DTC Description Action PCM P0030:00 HO2S Heater Control Circuit (Bank 1, Sensor 1): No Sub Type Information GO to Pinpoint Test D..

    Categories

    Removal and Installation - Steering Column Shaft

    Removal

    NOTE: Removal steps in this procedure may contain installation details.

    NOTICE: Do not allow the steering column to rotate while the steering column shaft is disconnected or damage to the steering column internal sensor may result.

    NOTE: Use a steering wheel holding device (such as Hunter® 28-75-1 or equivalent)

    Hold the steering wheel in the straight-ahead position.

    read more

    Copyright © 2025 www.foecosport2.com